Magnetic BEC 5A

(1 customer review)

53.00

Designed for DLG and HLG model gliders. Lightweight BEC, less than 5g.
+10 in stock

SKU: 30898702000201 Category: Tags: ,

Description

Introduction
As our other products, the Zepsus Magnetic BEC “linear voltage regulator” was designed with one thing in mind, we must not compromise on quality. With that in mind, the best components have been selected. No cheap solutions, this is the best of the best all the way around.
It outperforms many of its competitors with massive 200µF high quality low ESR stabilization capacitors. On-off indication is a super bright LED, visible through some fuselage.

On/Off Function
A clean and easy way to turn on your model, just slide the magnet across the marked area. The switch is mounted inside of the fuselage, out of the air stream, and the magnet will easily activate the switch from outside. No more fumbling for little switches, or plugging in connectors.

Failsafe
This produckt has a built-in failsafe function. It remembers its state for at least 10 sec, if disconnect from the battery. It will protects the switch against power glitch caused by bad battery connection etc.

Stand-by Consumption
The switch has an ultra low stand-by consumption in off-state. The consumption is so low that the switch can be connected to a small battery for several years without discharging it.

Four reasons to buy the Zepsus Magnetic BEC

  • The Magnetic BEC has the same well-known and well-tested magnetic technology as the Zepsus Magnetic Switches.
  • If a servo burns out in flight, the extreme high peak current will help the Magnetic BEC provide power to continue the flight and burn the servo electronics. Other BEC will give up, resulting is a crashed plane.
  • No buck or boost converter. No charge pump. No switching noise. This makes the Zepsus Magnetic BEC a ultra low noise product suitable for radio controlled gliders where a long range is very important.
  • Ultra low dropout voltage provides security if a battery cell collapses and input voltage suddenly drops below selected output voltage.

Technical Data
Input voltage range: 3~10V
Designed for 2s Lipo/Liion/LiFe or 5s NiMH/NiCD batteries
Output voltage: 5V
Output current continuously*: 5A
Output current burst*: >20A
Ultra low stand-by current: 6µA (micro-ampere)
Max power loss continuously: 3Watt
Max power loss burst: >20Watt
Ultra low dropout voltage**: 72mV@4A
Connectors: JR-type
Wire: high-quality 0.25mm2
Weight including cables 10cm: 4,9grams
Length including cables: 25cm
Dimensions including heat shrink: 40 x 15 x 5mm
Operational temperature range: -40C to +125C

*Depending on Input and Output voltage.
**If input voltage drops below output voltage.
Test at +20C ambient temperature

Calculation example of continuous current:
Max power loss continuously / (Input voltage – Output voltage) = current continuously

2S Lipo nominal voltage 7.4V and output voltage is 5V.
3 / (7.4 – 5) = 1.25A

Production test
All BEC have been tested with more then 30A burst followed by 7A for 5 sec before delivery. Standby consumption is controlled and a visual inspection is made.
All test done with 8V input.

Recommendations
We recommend the New Smart Magnet Holder or Magnetic keychain for all our products.

Price includes
Magnet and Stickers

1 review for Magnetic BEC 5A

  1. Anders Jonsson (verified owner)

    Work’s perfect!
    Good quality!

Add a review

Your email address will not be published. Required fields are marked *